SEC | Security -

On Windows, the software that runs the Android Emulator is called "qemu-system-x86_64.exe".

Try to kill this software. You can use the built-in taskkill utility from within the Command Prompt:

1. Open the Command Prompt (Type in CMD into the Windows search)
2. Enter: taskkill /F /IM "qemu-system-x86_64.exe" /T

Explanation of the taskkill command:

Simply register two transits callbacks (i.e. one per vehicle type)

Then use the overload of AddDimension() to pass an array of registered transit callback index.

e.G. Mizux/vrp_multiple_transit.py

There appear to be two key issues:

Enter/Update/Exit

The exit selection only contains elements when there are selected elements in the DOM which do not have corresponding items in the data array. In your case we have an empty selection with bound data:

The below works. There are two steps:

1. Make a mask to select the right rows
2. Then do the groupby and sum on only those rows

Mask function:

Here I'm wondering about the line [in s_client]
New, TLSv1/SSLv3, Cipher is ECDHE-RSA-AES256-GCM-SHA384

You're apparently using OpenSSL 1.0.2, where that's a basically useless relic. Back in the days when OpenSSL supported SSLv2 (mostly until 2010, although almost no one used it much after 2000), the ciphersuite values used for SSLv3 and up (including all TLS, but before 2014 OpenSSL didn't implement higher than TLS1.0) were structured differently than those used for SSLv2, so it was important to qualify the ciphersuite by the 'universe' it existed in. It has almost nothing to do with the protocol version actually used, which appears later in the session-param decode:

TL;DR. You should check that the pointer returned by bpf_map_lookup_elem is not NULL.

With the following logs, the BPF verifier is telling you that, when it reaches the dereference of my_pid, the pointer may still have a NULL value. It thus contains a map value or a NULL value, i.e., map_value_or_null.

You can just call it this way as it recommends in the docs here

Example from the docs:

Your code has an error in it, which is the use of break statements within the if and else clauses. If you remove the breaks, it should work.

break statements can only be used within for/while loops and switch statements. You can't use them (and don't need them) in if/else statements.

If you click "run code snippet" on your example, it shows the error message Uncaught SyntaxError: Illegal break statement which would help you find this issue. Also, if you open your browser's JavaScript console, you should find this error message where you are running your code. This will help you find and fix errors in the future.

Yes: