mugen | Microlibrary for implementing infinite scroll on Android | RecyclerView library

Move these two lines inside the forEach loop, also replace the movieId with movie.tmdbid and voila you are all set.

You can use binding prefix，change your code like below:

The consistent difference between existing and non-released films is the attribute data-film-session and data-film-exp. Only add to the list if the entry has one or both of these attributes. This is untested, it may not work, but it's a step in the right direction.

See Troubleshooting - The data directory must be accessible

The data directory must be configured with the appropriate permissions and ownership settings to allow the mongod to read, write, and navigate the directory contents (rwx user or group permissions).

You must permit user mongod to write to this folder. Or you could add user mongod to group mugen for example.

This behavior kind of makes sense - the file (symbolic link) exists, but you can't read it because it points to a file that doesn't exist (broken symbolic link).

Personally, I'm not a big fan of these pre-checks. First, they are racy by nature - even if all the checks pass, something can happen on the file system after that and before you try using the file (admittedly, it's less of an issue in a local filesystem, but I still think it's a bad practice). Second, it's expensive - all these checks perform at least some I/O, and often redundantly so (since you'll perform the same I/O again when you open the file).

I'd just attempt to open the file, and catch the exception: