rak833-spi | Install script for using RAK833 SPI Adapter card

Plug in the RAK833 Adapter PCB with the RAK833 module connected. Start your RPi connected to Ethernet. From a computer in the same LAN, ssh into the RPi using default pi user (for IP address see HMDI output). Default password for user pi is raspberry. Edit /boot/config.txt and add the line below to the bottom to enable the SPI interface (or alternately use raspi-config).
Plug in the RAK833 Adapter PCB with the RAK833 module connected
Start your RPi connected to Ethernet
From a computer in the same LAN, ssh into the RPi using default pi user (for IP address see HMDI output) local $ ssh pi@192.168.1.135
Default password for user pi is raspberry
Edit /boot/config.txt and add the line below to the bottom to enable the SPI interface (or alternately use raspi-config) dtparam=spi=on
Reboot
Make sure you have an updated installation and install git: $ sudo apt-get update $ sudo apt-get upgrade $ sudo apt-get install git
Create new user for TTN and add it to sudoers $ sudo adduser ttn $ sudo adduser ttn sudo
Logout and login as ttn and remove the default pi user $ sudo userdel -rf pi
Ethernet connection is recommended, if you still want to use WiFi configure the WiFi credentials (check here for additional details) $ sudo nano /etc/wpa_supplicant/wpa_supplicant.conf network={ ssid="The_SSID_of_your_wifi" psk="Your_wifi_password" }
Clone the installer and start the installation $ git clone https://github.com/mypiandrew/rak833-spi.git $ cd rak833-spi/install $ sudo chmod +x *.sh $ sudo ./install.sh
If you want to use the remote configuration option, please make sure you have created a JSON file named as your gateway EUI (e.g. B827EBFFFE7B80CD.json) in the Gateway Remote Config repository.