klipper-voron-V2 | Generic Klipper configuration for CoreXY printers

The install of this config folder should not be too complicated if you are already familiar with the klipper configuration system. Here are the steps:.
Use an SSH connection to connect to your printer
Check if you already have a config folder in the ~/printer_data directory and remove it (or rename it to keep a backup).
Clone this config in the ~/printer_data/config directory. You can use the following command: git clone https://github.com/Frix-x/klipper-voron-V2.git ~/printer_data/config
Open and configure the printer.cfg file: you just need to uncomment the lines that suit your printer hardware configuration. Basically start by selecting the board_pins coresponding to your MCU, then select the components used and software config needed (such as extruder type, XY motors, Z motors, QGL vs Z_TILT, etc...).
Then, open the selected board_pins file in the config/mcus folder and add your MCU(s) serial port(s). Please follow the official klipper documentation to find it.
Check your wiring and verify that the selected board_pins file is correct. See pinout.md for more info
Now, open all the selected files in your printer.cfg and check that the pins are ok for your machine (regarding the board prefix name, the direction !, the pull-ups ^ or pull-downs ~). Note: this step is necessary because of a current Klipper limitation that doesn't allow me to put these symbols directly in the board_pins files... I'm still looking for alternatives.
Also, in the same way, open all the selected files in your printer.cfg and check the dimensions, the limits, the currents, and all the other values in every config sections. Pay a special attention to the axis limits in the [stepper_...] sections from the files located in config/hardware/XY or config/hardware/Z. Also check the thermistor types in [extruder] and [heated_bed], size of the plate in [bed_mesh], etc... Note: this step is necessary because of a current Klipper limitation that doesn't allow the use of variables in the config files... I'm still looking for alternatives.
Modify and adapt the variables.cfg file to suit the configuration of your machine. This file helps to configure and customize how all the macros should behave (coordinates of everythings, enabling/disabling software features, etc...).
Check very carefully all the features! This step is very important to avoid any problem on your machine. You can start by following the config checks from the official Klipper documentation. Then also verify that you are able to attach/detach the mechanical probe, do the QGL/Z_TILT, have the correct coordinates for all the used components (purge bucket, physical Z endstop, etc...). You should also verify your first layer calibration (and the switch_offset parameter from the automatic z calibration plugin if using it), etc...
Finally when everything looks to be working, you need to add the custom print start gcode in your slicer. Here is an example for SuperSlicer: START_PRINT EXTRUDER_TEMP={first_layer_temperature[initial_extruder] + extruder_temperature_offset[initial_extruder]} BED_TEMP=[first_layer_bed_temperature] MATERIAL=[filament_type] CHAMBER=[chamber_temperature] SIZE={first_layer_print_min[0]}_{first_layer_print_min[1]}_{first_layer_print_max[0]}_{first_layer_print_max[1]} Also add to your custom print end gcode in your slicer: END_PRINT