elain | Set the minimum alignments of types using const generics | SDK library

Just move you println() into the loop, and after that, change the sum back to 0.

You can do it with the $event parameter. Make sure to compare your values safely.

If your value is not in the right type or has spaces or unwanted chars, this c.state == val might not work.

You can use the trim function to compare your value safely: c.state.trim() == val.trim()

HTML

You can use .merge:

You can use ESLint's no-useless-escape rule, which will suppress warnings when you use escape characters that don't change the string's meaning. Also see this question and its answers.

As a bit of extra info, - in a regex only has special meaning if it's inside of square brackets [ ] and otherwise does not need to be escaped. None of the instances in your regex appear to be inside such brackets, so it's safe to say the regex will work the same if you do decide to just remove the escape characters.

The problem I see is that the correct value for ws-position shows on the next record; this happens because ws-calc-position is determined after the line is printed. This caused a blank on the first record and an incorrect value on the following print lines.

I suggest moving the code for determining ws-calc-position to just before it is needed. 120-process-lines and 220-process-rpt-lines incorporates those suggestions.

The IF code should not include AND, as expressed originally. It causes some values to be missed, where in-yrs-serv is 15, 07, or 02. Those particular values caused (or would cause) the previously determined position to appear in the output. That change has be made below.

Also, this line

You have two problems: The first is that %s will read space delimited "words", it won't stop at the :. The second problem is that the format %[^\n] reads all until newline.

So you need a scanset format for the first name as well as tell it to read until the next :, which is done with the format %[^:].

So please change to:

I'm pretty sure the issue the texture your rendering to is 8bits. Switch it to a floating point texture (RGBA32F) You'll need to check for and enable EXT_color_buffer_float and OES_texture_float_linear

You say it won't work on mobile but you're using WebGL2 which hasn't shipped on iPhone yet (2021/1/3). As for RGBA32F not being renderable on mobile you could try RGBA16F. You'll have to check for and enable the corresponding extensions, EXT_color_buffer_half_float and OES_texture_half_float_linear. Your current code is not checking that the extensions actually exist (I'm assuming that was just to keep the code minimal)

The corruption is that your circle calculation draws alpha < 0 outside the circle but inside the quad. Before that was getting clipped to 0 because of the texture format but now with floating point textures it's not so it affects other circles.

Either discard if c <= 0 or clamp so it doesn't go below 0.

Note: you might find coloring faster and more flexible using a ramp texture. example, example2

Also note: It would have been nice if you'd created a more minimal repo. There's no need for the animation to show either issue

Something else to point out, maybe you already knew this, but, the circle calculation

You can use map{}. Something like this:

I'm not sure if you can do it solely on the given array.

I would start by turning the array into an actual tree structure. You could for example have a Node class with a name (e.g. "alice") and a left and right attribute, referring to the child nodes: