fend | performance PHP framework that can switch | Application Framework library

The issue is that in the Matcher, by default each dictionary in the pattern corresponds to exactly one token. So your regex doesn't match any number of characters, it matches any one token, which isn't what you want.

To get what you want, you can use the OP value to specify that you want to match any number of tokens. See the operators or quantifiers section in the docs.

However, given your problem, you probably want to actually use the Dependency Matcher instead, so I rewrote your code to use that as well. Try this:

For me how I did something similar was like so: In the back end (Spring):

The following seems to work. I used lead (after arrange to order by date), and some tweaks to avoid dropping groups with only one date

With both of your buttons tied to ground, and using PULL_UP the code is just:

0.01 second is way too short. The key is, after you detect "button down", you need to wait for "button up". You need something like:

Do not close your connection in the db_connect function and you need to return a conn from this function as well.

There's a lot of code there but just to address your specific question, you can use a function to generate your fields array:

There is no method in standard C++ to get the length of a function.

You'll need to use a compiler specific method.

One method is to have the linker create a segment, and place your function in that segment. Then use the length of the segment.

You may be able to use some assembly language constructs to do this; depends on the assembler and the assembly code.

Note: in embedded systems, there are reasons to move function code, such as to On-Chip memory or swap to external memory, or to perform a checksum on the code.

Constant Throughput Timer is precise enough at minute level, so if you configure your test to last longer - you will see the throughput going down gradually and after 1st minute it should be throttled to your 100 requests per minute.

If your scenario is to execute 100 requests evenly distributed across one minute you should rather go for Precise Throughput Timer or Throughput Shaping Timer which have immediate effect