drun | Run command in a selected docker image | Continuous Deployment library

This machine has had multiple version of Java JDK installed and multiple version of multiple IDEs (Netbeans, IntelliJ, Eclipse, etc.) Most recently, I have added JDK 15.0.2 and Netbeans 12.2. When trying to compile a simple "Hello World", this is the output that results:

TL;DR: documentation states I have to enable a specific memory region in the microcontroller before I can use it. However, I can use it before enabling it, or even after disabling it. How is this possible?

I'm currently developing an application for the STM32H743 microcontroller. I don't understand how the RAM seems to work correctly while the clock is disabled.

This MCU has multiple memories, spread over multiple power domains:

• In D1 domain it has ITCMRAM + DTCMRAM + AXI SRAM (64 + 128 + 512 kB)
• In D2 domain it has SRAM1 + SRAM2 + SRAM3 (128 + 128 + 32 kB)
• In D3 domain it has SRAM4 + Backup SRAM (64 + 4 kB)

I want to use the SRAM1. In the reference manual (RM0433 Rev. 7) it is stated at page 366 that:

If the CPU wants to use memories located into D2 domain (SRAM1, SRAM2 and SRAM3), it has to enable them.

In the register settings at page 452 it is described how to do this:

RCC AHB2 Clock Register (RCC_AHB2ENR):

SRAM1EN: SRAM1 block enable
Set and reset by software. When set, this bit indicates that the SRAM1 is allocated by the CPU. It causes the D2 domain to take into account also the CPU operation modes, i.e. keeping D2 domain in DRun when the CPU is in CRun.
0: SRAM1 interface clock is disabled. (default after reset)
1: SRAM1 interface clock is enabled.

So, the default value (after reset) is 0, which means the SRAM1 interface is disabled.

In this thread on the STM Community forum the question was why the D2 RAM wasn't working correctly and the solution was to enable the D2 RAM clocks. The "correct" way to do this is in SystemInit() (part of the STM32H7 HAL). In system_stm32h7xx.c we can find the following code parts:

I am upgrading a springboot app from 1.X to 2.1.3.RELEASE. My Springboot is a multi module project setup which is triggered using a java command something similar to this.

Using STS my cloud function works fine locally using the below command:

mvn function:run -Drun.functionTarget=functions.Gcpfunc

However, when doing a local Source or pre-packaged Lite JAR deployment, the build logs on GCP show error at the below stage:

I migrated my test from JUnit 4 to JUnit 5. All works fine but the translation of my previous annotation:

i have to write a code to make an external merge sort. This part is phase 1 where it writes {num_blocos} files with 400KB sorted files:

I'm running a springboot app on Java 8 environment

The command I use to run my app is this:

After created an index.ts and wrote a simple code for listening to port 3000 and printing hello world on the body, I'm also not able to run or get the output from deno's drun module.

I have eclipse-hono installed in one machine and Eclipse ditto installed in the other which is connected to same WIFI. I am trying to consume data from Eclipse hono to Eclipse ditto.

I have created a tenant named tenantallAdapters and registered a device named 4716.

Let us assume that I need to send the temperature sensor data from the registered device in the tenant to a Hono consumer as shown in the below snippet.